How to Fix a Noisy Fan Sound On Asus Netbook

Step-by-Step as follows :

1. Open the laptop battery, and disconnect all 4 small nuts that are inside

2. Still in place battery, Spread apart the frame edge keyboard with netbook casing and pull gently

3. On the left and right side, there is a hook to be removed. To do this, use a small screwdriver to push the latch. Do both the left and right

4. If you have, see the top of the netbook. Spread apart the keyboard cover with the bottom case. Look at the picture and did well on the other side the same way

5. Do the above until around the keyboard is open, as shown

6. Lift the keyboard cover, be careful with the cable connectors that are linked to the motherboard

7. Disconnect all existing nut and we will open the inner casing netbook

8. In order to facilitate us in opening up all the glue on the nut casing, unplug the keyboard from the motherboard. By sliding the white slots as data cable clip. Be careful when pulling, not too strong due to the very thin cable connector

9. After all the nut is removed, it is time to open the casing. Start by lifting the cover or casing left netbook. View image

10. Continue to loosen the back of the netbook. Use a thin object to enter the gap

11. Do it up all around the edge of the netbook is open, remember do not force too strong if there is a part that is difficult

12. After all is open, now pull the casing cover. Be careful not too strong, because there is no cable connectors to the motherboard

13. Focus your attention on the fan, on the left. Open the first all nuts the glue on the fan to the motherboard

14. Unscrew the nut fan

15. After all apart, remove the fan and brass. Be careful no fan power cable is still connected to the motherboard

16. Be careful with the fan power cable

17. Remove the fan cover brass, use a very small screwdriver to open the netbook fan

18. Take the fan wheel, check to see if a lot of dust around it. If more then immediately clean

19. Use a toothbrush or a soft brush to clean between the wheel and around the coil

20. Fan sound is usually caused by dry lubricant in the middle of the coil. Therefore, apply stemplet (soft oil) lightly at the middle of the iron mill as the center of rotation. And also rub around the inside of the wheel, because this section in contact with the coil in the middle. Remember only a few.

21. Good Luck